SHARP DRIVER MAC PASSWORD
Enter admin for both the username and the password when prompted.Press Windows Key+R to open the run window, then type \\*MachineIPaddress*\Shared and click OK (put your machines IP in the path).MAC USERS – SKIP TO STEP 18 WITH THE RED FONT BELOW.Click the Address book tab on the web page and wait until the page loads to indicate the machine is back online.At this point the copier will reboot – this takes about 30 seconds.Click Port Control on the left menu, then scroll down and enable NBT/WINS (on the newer models you will have SMB instead of NBT/WINS) and then click Submit.
Scroll to the bottom of the Quick Settings page and make sure the NAS is Enabled, if it’s not, change it to Enabled and click Submit.Click System Settings Tab, then Click Network Settings.The password by default is “admin” then click login Type the administrator password for your Sharp device into the password box.Open the Sharp web page by typing the IP address into an address bar of your favorite web browser and click Login at the top-right corner.Step By Step Instructions on How To Scan to Sharp Copier Hard Drive and Retrieve
SHARP DRIVER MAC HOW TO
Video Instruction on How To Scan to Sharp Copier Hard Drive and Retrieve How to print your network configuration page.Touch Settings on the home screen, touch Status tab, touch Network Status on the left, then scroll down to find IPv4 Address.SMB2 not required – no SMB vulnerabilitiesīefore you get started you’ll need your machine’s IP address.It requires no domain/network username and password.Mac FTP sharing was removed from Mac OS, so this will allow you to scan to folders with a Mac, rather than email.The following how-to will show you how to setup and use your Sharp copier’s hard drive as a shared folder that you can scan to and grab documents from, whether you’re using Windows or Mac. How To: Scan to Sharp Copier Hard Drive and Retrieve from Windows and Mac Computers
0 kommentar(er)
